Answering 24/7Marin · San Francisco · North Bay · East Bay · Peninsula
Licensed general contractor · CSLB #1071905
MM Bay Construction & Restoration
  1. Home
  2. Guides
  3. Water Damage at Home: What to Do in the First Hour
Guide · 6 min read

Water damage at home: what to do in the first hour

The short answerIn the first hour, get everyone safe, shut off the water at the main valve, cut power to wet areas only if you can reach the panel from a dry spot, and photograph the damage before you move anything. Then call a water damage company that can start drying the same day. MM Bay Construction & Restoration answers 24/7 across the Bay Area and sends a crew right away.

What should I do first when water is coming into my house?

Work in this order: people, then the water, then the paperwork. Most of the damage from a burst pipe or a failed supply line happens in the first few hours, so speed matters. Still, nothing in the house is worth an electric shock or a fall on a wet floor.

  1. Check for electrical and gas danger before you walk into the wet area.
  2. Stop the water at the fixture or at the main shutoff valve.
  3. Photograph and film everything before you move furniture or pull up rugs.
  4. Protect what you can safely: lift belongings, move valuables, put buckets under drips.
  5. Call a water damage company and your insurer. Drying should start the same day.

Is it safe to stay in the house?

Usually, yes, but check three things first.

Electricity. Water and power together are the biggest danger in the first hour. If water is near outlets, power strips, appliances or a ceiling light, turn off the power at the main breaker, but only if you can reach the panel while standing somewhere dry. If you would have to walk through water to reach it, stay out of that area and call an electrician or PG&E. Never touch a switch, cord or appliance while you are standing in water.

Gas. If you smell gas or hear hissing, leave the house right away. Do not flip light switches or use anything that can spark on your way out. Once you are outside and away from the building, call 911 and PG&E at 1-800-743-5000.

Ceilings and floors. A ceiling that sags or bulges can come down without warning. Keep people and pets out from under it. Soft or bouncing floors over a crawl space are another reason to keep out of a room until someone looks at it.

If the water came from a sewer line or a toilet backup, keep children, pets and anyone with a weak immune system away from the affected rooms. That water carries bacteria and needs protective gear to clean up.

How do I shut off the water to my house?

If the leak is at one fixture, start there. Toilets, sinks, dishwashers, ice makers and washing machines each have a small valve on the supply line, usually behind or under the fixture. Turn it clockwise until it stops.

If the leak is in a wall, a ceiling or a pipe you cannot see, shut off the whole house at the main shutoff valve. In most Bay Area houses it sits where the water line enters the building: on an outside wall near the front hose bib, in the garage, or in the basement or crawl space. There are two common types:

  • Gate valve (a round handle): turn it clockwise, several full turns, until it stops.
  • Ball valve (a lever): turn it a quarter turn so the lever sits across the pipe instead of along it.

If the house valve is stuck or you cannot find it, the water utility has a shutoff at the meter box near the street. It usually takes a meter key, and many utilities will send someone to shut it off in an emergency.

If the water heater is the source, shut off the cold water valve on top of the tank, then turn the gas control to off or switch off its breaker. In a condo or apartment, the unit shutoff may be in a closet, a utility room or behind an access panel. Call the building manager or HOA right away, because the leak can reach the units below.

What photos do I need for insurance?

Take them before anything is cleaned up or moved. The California Department of Insurance advises keeping damaged items until your adjuster says they can go, and saving receipts for anything you spend to prevent further damage. A good first set of photos includes:

  • A wide shot of every affected room, taken from the doorway.
  • The source: the broken pipe, the failed supply line, the leaking water heater or the stained ceiling.
  • The water line on walls, cabinets and furniture legs.
  • Close-ups of damaged belongings, with brand names, model numbers and serial numbers where you can see them.
  • A slow video walk-through, narrating what you see.

Report the loss to your insurance company or agent as soon as you can, and start a simple log of every call: date, name, and what was said. For what is usually covered, read Does homeowners insurance cover water damage in California?

What should I not do after a water leak?

  • Do not use a household vacuum on water. It is a shock risk and it ruins the vacuum.
  • Do not turn on ceiling lights or fans in a room where the ceiling is wet.
  • Do not throw away damaged items before they are photographed and the adjuster has seen them or approved disposal.
  • Do not start permanent repairs, like new drywall or flooring, before the adjuster inspects. Emergency work to stop the damage is expected; the rebuild comes after.
  • Do not paint over a stain or close up a wall that is still wet. Trapped moisture is how mold starts.
  • Do not wait for it to dry on its own. Water runs under flooring, behind baseboards and into wall cavities where you cannot see it.
  • Do not touch sewage water without gloves and boots, and keep it off your skin.

What can I do while I wait for the crew?

Only the things that are safe and easy:

  • Move electronics, documents, photos and rugs out of the wet area.
  • Set furniture legs on aluminum foil or plastic blocks so the wood stops wicking water and the carpet does not stain.
  • Pin up curtains and lift anything sitting on wet carpet.
  • Mop or towel up standing water on hard floors if there is no electrical risk.
  • Put a bucket under any ceiling drip, and keep the area clear.

Skip the heavy lifting. Wet carpet and soaked drywall are much heavier than they look, and the crew has the pumps and extractors to do it faster.

When should I call a water damage company?

Call when water has soaked into anything porous: drywall, carpet, wood floors, cabinets, insulation or a ceiling. Call also when you cannot tell how far it spread, which is most of the time. A small spill on tile that you wipe up in minutes is fine to handle yourself. A leak that ran for an hour behind a wall is not, because the water you can see is a fraction of the water in the building. Professionals use moisture meters and thermal cameras to find it, then dehumidifiers and air movers to dry it. The EPA notes that when wet materials are dried within 24 to 48 hours, in most cases mold will not grow, which is why the first day matters so much. Our guide on how long drying takes explains what happens next.

How MM Bay helps in the first hour

When you call (415) 878-3410, a person answers, day or night. We can talk you through finding your shutoff valve while a crew heads your way. On site we stop the water, pump and extract it, map the moisture, and start drying the same visit, with photos and readings recorded for your adjuster from the first hour. Because MM Bay is a licensed general building contractor, we also fix the pipe or line that failed and rebuild what was removed. See how our emergency water removal works, or read about working with your insurance company.

Frequently asked questions

Should I turn off the water heater if a pipe bursts?

If you shut off the main water valve for more than a short time, it is a good idea to turn the water heater off too: set the gas control to off or switch off its breaker. That protects the heating element or burner while no water is flowing in. When the water is back on and the tank is full again, turn it back on.

Can I use a shop vac to remove water from my floor?

A wet/dry shop vac is fine for a small amount of clean water on a hard floor, as long as there is no electrical risk and you plug it into a dry, grounded outlet away from the water. It will not pull water out of carpet pad, subfloor or wall cavities. For anything larger, professional extraction and drying equipment does the job properly.

How do I know if water got under my floor?

Signs include boards that cup or lift at the edges, vinyl or laminate that bubbles, grout that stays dark, a musty smell, or water showing in the crawl space or basement. Often there is no visible sign at all in the first hours. A moisture meter reading on the flooring and subfloor is the reliable way to know.

Should I open windows to help the house dry?

Opening windows helps only when the outside air is drier than the inside air. On a cool, damp Bay Area night it can make things worse. Professional drying usually keeps the space closed so dehumidifiers can pull moisture out of the air efficiently. Ask the crew before opening up the house.

Written by the MM Bay Construction & Restoration team, a California licensed general building contractor (CSLB #1071905) based in San Rafael. This guide is general information, not legal or insurance advice; your policy and your adjuster have the final word.

Water where it shouldn’t be? We’re ready now.

Call any time, day or night. We’ll tell you what to do right away and send a crew.

(415) 878-3410Request service